GamePlanPinball.com Forums

General => Open Discussion => Topic started by: Drop Target on May 03, 2012, 10:00:38 AM



Title: New to GamePlan forum
Post by: Drop Target on May 03, 2012, 10:00:38 AM
I just registered to the site and thought I would say Hello. I own several Bally, Williams and Stern pins (EM's and SS's)and just purchased my first GamePlan. It's a non working Attilla the Hun. Backglass, playfield and cabinet are in great shape. Boards look good. (Have not done any test point checks as of yet) it has a burnt flipper coil, so my first look will be the SDU. I am very excited about getting this pin up and running and adding it to my game room.
 Anyway, Hello to All!


Title: Re: New to GamePlan forum
Post by: Pinball Shark on May 05, 2012, 10:30:04 AM
Welcome to the site! Did you check the flipper EOS switches?


Title: Re: New to GamePlan forum
Post by: Drop Target on May 06, 2012, 08:45:36 AM
Thanks. Yes, I worked on the flippers, replaced burnt coil and coil sleeve on the other flipper. cleaned everything up and tightened a few mounting screws. Turns out there is a small amount of corrosion on the mpu. All test points check out on mpu and rectifier boards. I have ordered chips and sockets. Looks like damage is isolated to u26.